Renesas usb 3.0 extensible host controller driver windows 7

Renesas usb 3.0 extensible host controller driver windows 7 install#
Renesas usb 3.0 extensible host controller driver windows 7 drivers#
Renesas usb 3.0 extensible host controller driver windows 7 update#

Renesas usb 3.0 extensible host controller driver windows 7 drivers#

The sad thing is this is my job, I am deskside support for my company and I can't find an answer, which leads me to believe that this isn't fixable right now, and maybe has to wait until a later date when new drivers are put out. I really do use my USB 3.0 and it may be a deal breaker for Windows 8 do you have any suggestions? The renesas electronics website is useless. I have uninstalled, and disabled and restarted so many times.

Renesas usb 3.0 extensible host controller driver windows 7 update#

So I tried the Windows drivers from Windows update and same thing.

Renesas usb 3.0 extensible host controller driver windows 7 install#

I performed a clean install from DVD and everything was recognized fine except the Renesas Electronics USB 3.0 Host Controller.Дell has Windows 8 drivers for the USB 3 on the website so I tried to install them and get a code 10 device could not start. They seem to be somewhat related.I ran the upgrade assistant and it showed no issues for me to upgrade to Windows 8. Once the disk queue length dropped down to 1-2, the system was manageable again.Дon't know if that problem will repeat with the new drive at some point, but I would care not to take chances and just get the board replaced at this point. That behavior would go on for the first 15 minutes of boot, and perfmon showed a long disk queue length during that fifteen minutes.

Also, VAIO Gate, one of the programs built in that loads on startup, would cause my mouse to hang, not move for a couple seconds, and then start to move from where it should have been based on the motion I used to move it. The system was slow: Mouse clicks did not respond immediately and sometimes took anywhere from 2-10 seconds to register, directory listings were slow to load, browser windows were the worst and just scrolling up and down a page could take 5-10 seconds for the scroll bar to even move, and when the scroll bar on the browser did move, it was often jerky. With the previous two drives, the behavior was erratic, but it was repeatable on nearly every boot. This one has been fine for over a month now. The second drive started failing after four or five days of use. Both drives were fine when I initially used them, and the first drive started failing after months of use. In my case with the previous two drives, the hard disk drive controller seemed to be magnafoozled on both. NEC Electronics USB 3.0 Host Controller Driver (previous BSOD issues with 2010 version) No updates are available through Sony, and I am having a difficult time finding them through Renesas Support. I believe this is a driver issue related to the blue screens that occur with the driver version installed on my system. I have a SanDisk 16 GB USB 2.0 drive that works fine. I do not have this problem if I use the one and only USB 2.0 port on the system. If I try to move files off my system onto the flash drive and then also try to move/copy files within the flash drive to a different folder, the drive disappears from the system and I get a message that the destination path does not exist anymore. Ever since I bought this system, I have had issues with an older Kingston 8 GB USB 2.0 flash drive.